planes – Page 5 – Stochastic Geometry

Home / Tag "planes" (Page 5)

Blood, gouges and drawbores

Baby blanket chest Woodcarving Woodworking

Started off the day with the noisier tasks to get them out of the way…

There’s not a lot of art here. Rive the stick to about the diameter you want, pound it through the hole with the big hammer several times, move on to smaller hole until desired size reached, sharpen slightly, continue on. And it’s noisy, so ear defenders. But, keep going and you finally have all you need minus one (because the universe hates you, there will always be a need for one more than you have).

Then on to finishing off the carving.

It’s a fairly simple design on the bottom. Mark off every inch on the two reeds I cut yesterday.

Then chop down vertically with the gouge (whose profile matches the reed pretty closely) on each spot on one reed.… Read the rest

Mark Dennehy in 22 Jan 2018 1 Comment

Too many inches

Baby blanket chest Tools Woodcarving

Woodworking

Quite a bit of time in the shed today, so made some progress (there being a nearby deadline, this is a good thing). Started by cutting a side rail’s tenons, then marking off the other side rails from it (same as for the long rails).

I wanted to keep using the offset shoulder idea, but rather than gauging it by eye, which I can’t do yet, or sawing on one or the other side of the line, which I also have trouble doing, I decided to just mark out the shoulders and cut to the line. So I marked off the show face shoulder, ran the line round with the square to the back side, and then marked out 5mm or so of the line on the back side, then put a ruler on the line and butted the square up against that.… Read the rest

Mark Dennehy in 21 Jan 2018 3 Comments

Offset shoulders

Baby blanket chest Tools Woodworking

Started off with a quick check of something for Ralph who’d had a minor mishap over on Accidental Woodworker with his #044.

Ouch. Cast part weakness strikes again 🙁

For Ralph, my #044’s rods are square to the fence to within 0.05mm (my thinnest feeler gauge):

And square to the skate to the same tolerance:

And there are gaps around the rod in the fence holes. It’s hard to gauge how much by because my feeler gauges are flat and don’t cope with tight radii well, but it looks somewhere around 0.1mm.

There is a discernible line around the rod in the plane body, but no discernible gap and I can’t get even the tip of the 0.05mm feeler gauge in there.

Incidentally, I normally have the fence rods a few inches proud of the body of the plane like that because its spot on the wall sees it stay in place using both the rods and the secondary fence on the plane:

Hope that helps Ralph.… Read the rest

Mark Dennehy in 20 Jan 2018 2 Comments