Home / Tag "walnut" (Page 16)

Ending, restocking, brexit and black friday

Baby blanket chestBandsaw BoxesFinishing
More
ShedToolsWoodworking

Looooong day. I had a callout over the weekend at midnight on Saturday so I had a few hours off in lieu that I took this morning to go to the timber yard. One of the next projects coming up could use some 8/4 oak so my shopping list was a 6-8″ board of 8/4 oak between 8′ and 12′, an 8-9″ board of 4/4 oak around the 12′ mark, and possibly the same two boards again in walnut. And I thought I’d take a look at the beech and get a small board of that to try working in it.

You know how plans rarely survive contact with reality?

So, Brexit. And now any timberyard here in Ireland has a choice – either get hardwoods direct from the continent via ship which is more expensive than road haulage; or buy it from the continent and drive it back home through the UK with all the customs hassle on both coasts which is expensive; or do what they’ve done till now and buy smaller quantities from UK timberyards and ship it back on the ferry to here, but now paying higher prices because the pound has collapsed, and next year, paying higher prices again because the UK is having to pay customs duties of 20% or more on their imports from the EU (because the UK does not grow enough timber for itself and hasn’t since the 18th century), and then paying higher prices again because of customs duties re-importing that timber back here.… Read the rest

Read More
Mark Dennehy in 2 Comments

Flattening and boxes

Bandsaw BoxesSide TableWoodworking

So, started off flattening the apron. This went pretty well after I switched over to the #5 and sharpened it up a bit. The narrower blade means less pushing effort and that seemed to help a lot. And then it was time to thickness down from an inch to 3/4 of an inch.

This is not my favourite activity. And honestly, if they made an induction motor benchtop thicknesser I’d have bought one already, but unfortunately they’re all universal motor things — and lunchbox thicknessers, even if you fit them with helical blades and all the fancy doo-dads, are just too damn noisy to run in a housing estate. You’ll wind up triggering a torch-and-pitchfork party of your very own if you do that round here once too often.… Read the rest

Read More
Mark Dennehy in No Comments

Progress and mucking about

GeneralSide TableTools
More
Woodworking

So I figured I’d start by playing with the new toy and taking some test cuts.

The blade runs sort-of true. Well, I wasn’t expecting laser levels of perfection here, but the guides really are letting things down. The lower thrust bearing can’t be backed off readily to adjust it so it’s not poking the blade out of true, which is disappointing. And I really can’t run this thing without dust extraction or the whole lower case clogs up and the bearing itself locks up. Well, I knew machinery would counter its speed by increasing the amount of faffing about needed to support it. This is why you usually mount this stuff permanently where you have room to manoeuvre around it. But again, 8’x6′ shed, no room to think, let alone manoeuvre, so we need to make do.… Read the rest

Read More
Mark Dennehy in No Comments